ENGGN22/01/2026
 
Scheda
 Marine Equipment
Verifica della produzione mediante controllo dei prodotti
Module: G
Certification N. MED787825WS/001
Certificate date 1/22/26
Type Prevenzione dell'inquinamento marino
Directive (EU) 2025/1533
Product Sistemi di trattamento dei gas di scarico a bordo
Item Nº MED/2.10
Model MPUSOx/U-3000 OPEN LOOP
Identification OSU25305-0001-8124 intended for Main Engine and Auxiliary Engines
Applicant CHINA ZHEJIANG ENERGY MARINE ENVIRONMENTAL TECHNOLOGY CO., LTD.
Place of requester 601,Building3 NO.371,Mingxing Road, Economical and Technological Development Zone, Xiaoshan Area, Ha Hangzhou (Zhejiang)  % CHINA
Tel. N.,Fax, Email 0571-86605111, ---, liuyifan@zeme-china.com
Standards IMO Res. MEPC.340(77)
Surveyor Lin Weibing
Responsible Office RINA China Marine



UNIT VERIFICATION CONFORMITY (MODULE G)
CERTIFICATE No.  MED787825WS/001

This is to certify
that RINA Services S.p.A. did undertake the relevant conformity assessment procedures for the equipment of the manufacturer identified below, which was found to be in compliance with the Marine-Pollution prevention requirements of Marine Equipment Directive (MED) 2014/90/EU, including the requirements and testing standards of (EU) 2025/1533.
MED Item Nº MED/2.10
Description On board exhaust gas cleaning systems
Type MPUSOx/U-3000 OPEN LOOP
Identification OSU25305-0001-8124 intended for Main Engine and Auxiliary Engines
Applicant CHINA ZHEJIANG ENERGY MARINE ENVIRONMENTAL TECHNOLOGY CO., LTD.
601,Building3 NO.371,Mingxing Road, Economical and Technological Development Zone, Xiaoshan Area, Ha Hangzhou (Zhejiang)
CHINA
Testing standards IMO Res. MEPC.340(77)
    
Issued in RINA China Marine 
on January 22, 2026

This Certificate consists of this sheet plus an attachment
This certificate authorises the Manufacturer or his authorised representative established within the Community to affix the following symbol on the equipment above identified.
0474 /26
 

________________________________________
RINA Services S.p.A. - Yongjun Pan
RINA Services S.p.A.
**** NOTICE: This is NOT an official certificate ****
ATTACHMENT TO
CERTIFICATE No. MED787825WS/001
Place of unit verification
ON BOARD OF M/V VELOS STAR (IMO: 9728124),,

Verified components of the equipment (with serial number)
OSU25305-0001-8124 intended for Main Engine and Auxiliary Engines
Technical documentation
1) Following statutory document have been approved/filed in compliance with IMO Res. MEPC.340(77):
- SHMC/36884 approved on 03/07/2025 "SOx EMISSIONS COMPLIANCE PLAN (SECP)"
- SHMC/36885 approved on 03/07/2025 "EGC RECORD BOOK"
- SHMC/36886 approved on 03/07/2025 "EGC SYSTEM TECHNICAL MANUAL (ETM-B)"
- SHMC/36887 approved on 03/07/2025 "EGC ONBOARD MONITORING MANUAL (OMM)"

2) Product description:
The EGC unit from Zhejiang Energy Marine Environmental Technology Co.,Ltd, often referred to as a scrubber, is based on the wet scrubbing technology. This particular system uses the surrounding sea water as wash water, which is discharged once through, that it is described as an open system.
The entire monitoring system is designed according to MARPOL Annex VI, NOx technical code 2008 chapter 5 and its Appendix III and according to Section 6 of the Guidelines. A continuous stream of exhaust gas is Extracted from the funnel after the EGC unit. The sample probe draws in the sample stream which is led to the conditioning cabinet via a heated Sample line, where it is filtered and dehumidified before it is sent to the gas analyzer. The analyzer measures the SO2 and CO2 from where the Emission Ratio (ER) can be calculated. The measurements are logged every 90 seconds (the required interval is every 4.75minutes)

3) Completed Tests on board were carried out from Zhejiang Energy Marine Environmental Technology Co., Ltd during sea trial in accordance with IMO Res. MEPC.347(77) & approved documents, and relevant testing reports/ records are listed as below:
1. Commissioning test report;
2. Bunker Delivery Notes and laboratory analysis report;
3. RINA type approval certificate for Emission Monitoring system;
4. RINA certificate for scrubber control panel;
5. Calibration protocols/certificates of CEMS and water monitoring sensors;
6. Span gas analysis certificate;
7. RINA Certificate for the body of Exhaust Gas Cleaning System;
8. RINA Certificate for Electric Motors and Feed pumps;
9. Wash water sample nitrate analyses report from laboratory, and Certification for laboratory.

Limitation on the acceptance or use of the product
- Max. Exhaust Mass Flow Rate is 80370 kg/h
____________________________
General condition of approval
a) This certificate will not be valid if the manufacturer or user makes any modification to the equipment, which has not been notified to, and agreed with RINA

___________________________________
RINA Services S.p.A. - Yongjun Pan
RINA Services S.p.A.
**** NOTICE: This is NOT an official certificate ****