“Aquatech ®” is a manually/automatically operated water mist system consisting of nozzles, stainless steel piping, section valves, filters, control system and water supply pump(s).
Only the nozzles AQUATECH ® TS-WMC16 are within the scope of this certificate.
Pumps, pipes, valves, couplings and other systems components are subject to case by case approval.
Nozzle characteristics
- Material: brass OT58.
- Spray and steaming: radial 360°.
- Functioning: pop-up.
- Mist: from 50 to 150 micron.
- Filter: interchangeable stainless steel filter.
- Test pressure: 150 bar.
- Working pressure: 100 bar.
- Flow rate: 6,1 lt/min.
- Max installation spacing*: 10 m for ducts having cross section area not exceeding 0.5 m².
* for ducts having a cross sectional area more than that above specified, the arrangement will be evaluated case by case (reduced spacing).
Fields of application
Local protection for galley extract duct limited to a cross sectional area* of 0.5 m2.
Nozzle installation requirements
| Projection Discharge | perpendicular to the ducts |
| Max spacing from each nozzle * | 10 m |
K factor (lpm/bar1/2) | 0.61 l/min |
| Minimum working pressure | 100 bar |
| Maximum duct free sectional area * | 0.5 m2 |
| ATTACHMENT TO
CERTIFICATE No. MED483221CS
Page 2 of 3 |
Reference documents
- Sprayhead TS-WMC16, dwg n° TS031- Rev 1, issued by Tema Sistemi S.p.A. and approved by RINA with n° CSST-19767.
- Design, installation, operation and maintenance manual "MANUALE DI USO E INSTALLAZIONE SISTEMA DI SPEGNIMENTO AD ALTA PRESSIONE CON UGELLI TS-WMC16", dwg n° TS-MAN-WMC16 issued by Tema Sistemi S.p.A. and filed by RINA with n° CSST-19768.
- Nozzle datasheet, issued by by Tema Sistemi S.p.A. and filed by RINA with n° CSST-19809.
- Test report n° TS-WM/CM/01/19 issued by Brand Technology S.r.l. for Tema Sistemi S.p.A and filed by Rina with n° CSST-19810.
Remarks
a) Installation of the system, spacing of nozzles and components used shall be in accordance with the type approval documentation;
b) Prior to fitting the system on board, the following details shall be submitted for approval for each installation:
- Ducts layout and nozzles arrangement;
- Schematic arrangement of the system including sizes and material of piping and method of pipe jointing, nozzle types;
- Specification of the pump unit;
- Hydraulic calculation.
c) The nozzles shall be marked with the name of the producer and the type designation as indicated in this certificate.