| Elbow, Tee, Cross, Cap, Reducer, material: Cand C-Mn steel, Alloy Steel, Austenitic stainless steel, (Duplex) stainless steel |
Products: Tee, Cross, Elbow, Cap, Reducer
-Manufacturing process: Pipes fittings made from pipes with hot forming or cold drawing;
Material: | | Max. outer diameter [mm] | Max.wall thickness [mm] | Heat treatment condition 2) |
C and C-Mn | HFS | 610 | 31 | N |
Alloy | HFS | 610 | 31 | NT |
Austenitic Stainless | CFS | 610 | 31 | SHT |
Duplex Austenitic Stainless | CFS | 610 | 31 | SHT |
Remarks:
1) CFS: Cold finished seamless (tees); HFS: Hot finished seamless (elbows, reducers)
2) N: Normalised; NT: Normalised and tempered; SHT: Solution Heat Treated (solution annealing)
3) Suitable pipe fittings shall be selected from the following recognized standards:
EN 10253, ASTM A234, ASTM A403, ASTM A420, ASTM A774, ASTM A815, ASTM A960, ASTM A961,
JIS B2312, JIS B2313 or JIS B2316
Additional approval conditions:
Including pipe fittings in austenitic stainless steel for approved low-temperature applications
Note: Raw material is to be provided by Approved manufacturer.
Survey conditions:
The pipes fittings are to be in compliance in all respects with the requirements specified in Part D Ch 2 Sec2 of the RINA Rules and are to be tested accordingly.
General conditions for the approval
-The approval is granted on condition that the RINA Rules for the approval, manufacture, testing and certification of materials are complied with in all respects.
-RINA is to be notified of any change of materials, manufacturing process, quality control routines that may affect the validity of this certificate. |
|