MED269224CSENGD- -  -  N- NAVYCROSS MONOLATO A60 - Plugging System for electric cables transit on A-Class Bulkhead -N- S- S- -21/11/2024- Marine Equipment- - SN- S- - N-  - 852,534B2bisMarine EquipmentNumero Pratica,Direttiva,Norma,Schema,Richiesta,Validità,EmailR- MED269224CS- N-Nov 20, 2029852534
 
Form
  Marine Equipment(TO)
Certification N. MED269224CS - (ENG)
Certificate date 21/11/2024
Type Protezione antincendio
Product Penetrations through "A" Class divisions: (a) electric cable transits
Item Nº MED/3.26a
USCG Category N° 164.138

Model or Denomin.
Items
NAVYCROSS MONOLATO A60 - Plugging System for electric cables transit on A-Class Bulkhead
Applicant MARINONI S.P.A.
Place of requester VIA TAGLIOLINI 26 B  %  16152 Genova (GE)  % ITALY
Tel. N.,Fax, Email 010 659 651, 010 659 65 60, marinoni@marinoni.it
Directive (EU) 2024/1975
Standards IMO Res. MSC.307(88)-(2010 FTP Code) - IMO MSC.1/Circ. 1488
Reference Documents SOLAS 74 Reg.II-2/9, IMO Res. MSC.1/Circ.1655
Request 03/06/2024
Expire date 20/11/2029
EC TYPE-EXAMINATION (MODULE B) ENG
Vuoto Querysave
Enrico Cabella S

EC TYPE EXAMINATION (MODULE B)
CERTIFICATE No. MED269224CS

This is to certify that RINA Services S.p.A. (Notified Body No. 0474) did undertake the relevant type approval procedures for the equipment identified below, which was found to be in compliance with the Fire Protection requirements of Marine Equipment Directive (MED) 2014/90/EU, including the requirements and testing standards of Regulation (EU) 2024/1975.
MED Item Nº MED/3.26a
USCG Category Nº 164.138
Description Penetrations through "A" Class divisions: (a) electric cable transits
Type NAVYCROSS MONOLATO A60 - Plugging System for electric cables transit on A-Class Bulkhead
Applicant MARINONI S.P.A.
VIA TAGLIOLINI 26 B,16152 Genova (GE),ITALY
Testing standards IMO Res. MSC.307(88)-(2010 FTP Code) - IMO MSC.1/Circ. 1488
Reference standards SOLAS 74 Reg.II-2/9, IMO Res. MSC.1/Circ.1655
Issued in Genoa on
This Certificate is valid until
November 21, 2024
November 20, 2029
This Certificate consists of this sheet plus an attachment

________________________________________
Enrico Cabella
RINA Services S.p.A.
**** NOTICE: This is NOT an official certificate ****

ATTACHMENT TO
CERTIFICATE No.  MED269224CS
Page 1 of 2

Product description


Transits of electric cables, having maximum diameter of 54 mm, installed in A-Class steel bulkheads. These transits are composed of an “omega” shaped perforated steel sheet frame, 0.9 mm thick, applied on the edges of the bulkhead plating aperture. The frame is filled with one layer of mattress manufactured from alkaline earth silicate fibers THERMAL CERAMICS type Superwool Plus Blanket having density 128 kg/m3 and thickness 25 mm, and one layer of mineral wool ROCKWOOL type SEAROX SL 480 having nominal density of 200 kg/m3 and nominal thickness of 30 mm. The mattress manufactured from alkaline earth silicate fibers is coated by means of a layer of product named NAVYCROSS (density of 600 kg/m3), applied with a thickness of 40 mm, for a width of 40 mm all around the mattress. On the side coated with NAVYCROSS, the electric cables are covered all around, for a length of 80 mm, with a layer of NAVYCROSS having thickness of 15 mm. On the side opposite of the alkaline earth silicate fibers coated by means of a layer of NAVYCROSS, it is installed for a width of 40 mm by pins and washers, on the perimeter of the steel plate aperture, one layer of mineral wool ROCKWOOL type SEAROX SL 620 having thickness of 60 mm and nominal density of 100 kg/m3.

Field of application

Fire resistant A-60 cable transits through steel bulkheads, as per following table:
Transit dimensions (mm)
Minimum fill %
Maximum fill %
Cables - Maximum diameter (mm)
100x80
0.98
29.59
54
from 100x80
up to 450x240
0.98
12.19
54
450x240
0.09
12.19
54

Reference documents

Marinoni SpA drawings No. Dwg 12-23, Rev. 02, dated 30 October 2024 enclosed to RINA Test Laboratory report No. 2023CS014360/1, No. Dwg 01-24, Rev 02, dated 30 October 2024 enclosed to RINA Test Laboratory report No. 2023CS014360/2 and No. Dwg 02-24, Rev 01, dated 30 October 2024 enclosed to RINA Test Laboratory report No. 2024CS012692.

Tests carried out

Tests as per RINA Test Laboratory Report No. 2023CS014360/1, RINA Test Laboratory Report No. 2023CS014360/2 and RINA Test Laboratory Report No. 2024CS012692 issued on 15 November 2024 according to Appendix 1 of IMO 2010 FTP Code Part 3 - A.IV Cable Transits.




ATTACHMENT TO
CERTIFICATE No. MED269224CS
Pages 2 of 2
The mark of conformity may only be affixed to the above type approved equipment and a Manufacturer's Declaration of Conformity issued when the production control phase module (D, E or F) of Annex II of the Directive is fully complied with a written inspection agreement with a Notified Body
XXXX/YY
"WHEELMARK FORMAT"

XXXX
Notified Body number undertaking surveillance module
YY
Last two digits of year mark affixed
     
______________________________________________
General conditions for the approval
a) The initial conditions verified by RINA at the time of the approval are to be maintained
b) Any changes to the initial conditions are to be promptly communicated to RINA, which reserves the right to repeat the relevant assessment
c) This certificate will no be valid if the manufacturer makes any changes or modifications to the approved equipment, which have not been notified to, and agreed with RINA
d) RINA personnel are to be allowed to witness during the performances of activities, upon their request
e) The activities are to be carried out in compliance with the RINA Rules and/or other applicable Rules

f) Should the specified regulations or standards be amended during the validity of this certificate, the product is to be reapproved prior to it being placed on board vessels to which the amended regulations or standards apply. 


__________________________________________
Enrico Cabella
**** NOTICE: This is NOT an official certificate ****