Roller shutter having maximum clear opening width of 6000 mm and maximum clear opening height of 2480 mm. The roller shutter consists of:
- a shaft;
- a rolled shutter (door leaf);
- two guide channels.
The shutter, made of profiled stripes of stainless steel with width of 71 mm and thickness of 1 mm, is rolled to the shaft and is directed into the guides. The shaft diameter and thickness are, respectively, 114.3 mm and 2.5 mm for shutter having maximum clear opening width of 4000 mm and 133 mm and 3 mm in case of maximum clear opening width greater than 4000 mm. The guide channels are made of 2.5 mm S shaped stainless steel profiles (fixed, by means of M8 screws, to an L shaped carbon steel profile welded to the bulkhead) and 2.5 mm thick L shaped profiles fixed to the S shaped profile by means of M6 screws. In case of clear opening width greater than 4000 mm, the shutter is to be fitted, in the middle, with steel pin having diameter of 20 mm, fixed to the U shaped sill having thickness of 2 mm. Srips of stainless steel having thickness of 0.62 mm may be used in case of roller shutther having maximum width of 2400 mm and maximum height of 2480 mm (tested door).
Field of application Fire resistant A-0 Class door in compliance with IMO MSC.1/Circ. 1319 dated 11 June 2009. In this case the dimensions relevant to the height and width of the tested door may be increased of 15% provided that the surface area is not increased of more than 10%. For doors exceeding 50% in surface area with respect to the tested doors, the installation on board has to be submitted, on a case-by-case basis, also to a full analysis based on Solas Regulation II-2/17 (alternative design).
In case of doors in compliance to the "Agreement between the EEA EFTA States and the United States of America", the present certificate is valid at the following conditions:
- doors without windows;
- maximum door size tested;
- door used with a fire tested frame design.
Reference documents BLU BUD drawings No. 17039A001 dated 14 May 2018, No. 17039A020 dated 12 October 2018 and No. A00RS060 Rev. 7 dated 6 August 2019 approved on 16 May 2018, on 19 October 2018 and on 29 August 2019 respectively with endorsement No. LABS-1642, No. LABS-1741 and No. LABS-1887.
Tests carried out Test as per RINA Test Laboratory report No. 2018CS011519 issued on 16 May 2018 according to Appendix 1 of IMO 2010 FTPC Part 3. Increased dimensions verified with Technical Reports No. 2018-009-MTCST Rev. 0 dated October 2018 and No. 2019-008-MITHP Rev. 0 dated August 2019. |