ENGGN14/01/2025
 
Scheda
 Marine Equipment
Verifica della produzione mediante controllo dei prodotti
Module: G
Certification N. MED698824WS
Certificate date 1/14/25
Type Prevenzione dell'inquinamento marino
Directive (EU) 2024/1975
Product Sistemi di trattamento dei gas di scarico a bordo
Item Nº MED/2.10
Model SCRUBBER S-101
Identification S/N.D58-2578/C24-23, for Ship named: MATSON MAGNOLIA (IMO 9302578)
Applicant CYPRUS SEA LINES CO. LTD.
Place of requester 349, KIFISIAS AVENUE 14561 Kifisià  GREECE Athens  % GREECE
Tel. N.,Fax, Email ---, ---, ---
Standards IMO Res. MEPC.340(77)
Specified IMO Res. MEPC.176(58) - (Revised MARPOL Annex VI, Reg.4) and  IMO Res. MEPC.340(77)
Surveyor PAN Yongjun
Responsible Office RINA China Marine



UNIT VERIFICATION CONFORMITY (MODULE G)
CERTIFICATE No.  MED698824WS

This is to certify
that RINA Services S.p.A. did undertake the relevant conformity assessment procedures for the equipment of the manufacturer identified below, which was found to be in compliance with the Marine-Pollution prevention requirements of Marine Equipment Directive (MED) 2014/90/EU, including the requirements and testing standards of (EU) 2024/1975.
MED Item Nº MED/2.10
Description On board exhaust gas cleaning systems
Type SCRUBBER S-101
Identification S/N.D58-2578/C24-23, for Ship named: MATSON MAGNOLIA (IMO 9302578)
Applicant CYPRUS SEA LINES CO. LTD.
349, KIFISIAS AVENUE 14561 Kifisià GREECE Athens
GREECE
Testing standards IMO Res. MEPC.340(77)
Reference standards IMO Res. MEPC.176(58) - (Revised MARPOL Annex VI, Reg.4) and  IMO Res. MEPC.340(77)
    
Issued in Shanghai 
on January 14, 2025

This Certificate consists of this sheet plus an attachment
This certificate authorises the Manufacturer or his authorised representative established within the Community to affix the following symbol on the equipment above identified.
0474 /25
 

________________________________________
RINA Services S.p.A. - Hong Gu
RINA Services S.p.A.
**** NOTICE: This is NOT an official certificate ****
ATTACHMENT TO
CERTIFICATE No. MED698824WS

Verified components of the equipment (with serial number)
S/N.D58-2578/C24-23, for Ship named: MATSON MAGNOLIA (IMO 9302578)
Technical documentation
1.1 Technical Specification SHMC31680,
1.2 Onboard Monitoring Manual (OMM) SHMC31728,
1.3 Technical Manual, Scheme B (ETM-B) SHMC31682,
1.4 SOx Emission Compliance Plan, Scheme B (SECP) SHMC31681,
1.5 EGC Record Book SHMC31684,
1.6 Electrical Drawing SHMC20997,
1.7 General arrangement of Scrubber SHMC28536.

2. The EGC unit from Bluesoul, often referred to as a scrubber, is based on the wet scrubbing technology. This particular system uses the surrounding seawater as wash water, which is discharged once through, that it is described as an open system.
The entire monitoring system is designed according to MARPOL Annex VI, NOx technical code 2008 chapter 5 and its Appendix III and according to section 6 of the Guidelines. A continuous stream of exhaust gas is extracted from the funnel after the EGC unit. The sample probe draws in the sample stream which is led to the conditioning cabinet via a heated sample line, where it is filtered and dehumidified before it is sent to the gas analyzer. The analyzer measures the SO2 and CO2 from where the Emission Ratio (ER) can be calculated. The measurements are logged every 80 seconds.

3. Completed Tests on board were carried out from 20241223 to 20241224 during sea trial in accordance with IMO Res. MEPC.340(77) & approved documents, and relevant testing reports/ records are listed as below:
1. Commissioning test report;
2. Bunker Delivery Notes and laboratory analysis report;
3. RINA type approval certificate for Emission Monitoring system;
4. RINA certificate for scrubber control panel;
5. Calibration protocols/certificates of CEMS and water monitoring sensors;
6. Span gas analysis certificate;
7. RINA Certificate for the body of Exhaust Gas Cleaning System;
8. RINA Certificate for Electric Motors and Feed pumps;
9. Wash water sample nitrate analyses report from laboratory, and Certification for laboratory.

Limitation on the acceptance or use of the product
Max. Exhaust Mass Flow Rate is 344729 kg/h.
____________________________
General condition of approval
a) This certificate will not be valid if the manufacturer or user makes any modification to the equipment, which has not been notified to, and agreed with RINA

___________________________________
RINA Services S.p.A. - Hong Gu
RINA Services S.p.A.
**** NOTICE: This is NOT an official certificate ****