Single leaf hinged door whose maximum clear opening size is 1200 mm wide and 2200 mm high. The leaf has maximum width of 1247 mm and height of 2219 mm. The door leaf, having thickness of 50 mm, is composed of two carbon steel sheets, 1.2 mm thick each and, in between the insulating material. This material is composed of one layer of mineral wool type Knauf SEA-Tek BD 200, having nominal thickness of 48 mm and nominal density of 200 kg/m3. The insulating material is glued to the steel sheets by means of 3000 g/m2 of adhesive type Glueval 25. The leaf is fitted, on the perimeter, with C-shaped stainless steel profile, 1.2 mm thick and having dimensions of 52.4x15 mm. The leaf is fitted, at 230 mm from the edge lock side, with a vertical stiffener composed of double C-shaped steel profile 1.2 mm thick and having dimensions of 60x15 mm and with three reinforcement plates next to the perimeter of the leaf (corner and hinges).
The door frame is composed of a Z-shaped steel profile, 3 mm thick and having dimensions of 30x55x160 mm, screwed to the bulkhead. The sill, that constitutes the fourth side of the door frame, is composed of a C-shaped steel profile 5 mm thick, welded to the bottom. The door frame is insulated, on the exposed side, with one layer of mineral wool type Knauf SEA-Tek BD 200, having nominal thickness of 48 mm and nominal density of 200 kg/m3.
The door is fitted with a 1.2 mm thick stainless steel self-closing hose port having dimensions of 160x189 mm, insulated as the leaf.
The door is fitted with a stainless steel lock set type Razeto&Casareto.
Field of application Fire resistant A-60 Class single leaf hinged door with the fire hazard on both sides.
In case of doors in compliance to the "Agreement between the European Community and the United States of America", the present certificate is valid at the following conditions:
- maximum door size tested;
- door used with a fire tested frame design.
The surfaces of this division may be fitted with products having low flame spread characteristics, installed as described in the relevant type approval certificates and satisfying the requirements of SOLAS 74 Reg. II-2 as applicable.
Reference documents Naval Suppliers drawing No. HA61_Z2_1200x2200 Rev. 01 dated 05 May 2026 enclosed to RINA Test Laboratory Report No. 2026CS011145/3.
Tests carried out Tests as per RINA Test Laboratory report No. 2026CS011145/3 dated 10 June 2026 issued according to IMO 2010 FTP Code Part 3. |