ENGGN15/11/2021
 
Scheda
 Marine Equipment
Verifica della produzione mediante controllo dei prodotti
Module: G
Certification N. MED296521WS
Certificate date 11/15/21
Type Prevenzione dell'inquinamento marino
Directive (EU) 2021/1158
Product Sistemi di trattamento dei gas di scarico a bordo
Item Nº MED/2.10
Model Open Loop Scrubber
Identification S/N.: 100SC1 & 100SC2,
Intended for: M/V FINNECO I (IMO 9856830, RI 97927)
Applicant Langh Tech Oy Ab
Place of requester Alaskartano, Vanhamakarlantie 29  %  21500 Piikkio  % FINLAND
Tel. N.,Fax, Email +358 2 4779400, ---, sanna.rimpelainen@langh.fi
Standards IMO Res. MEPC.259(68)
Specified IMO Res. MEPC.176(58) - (Revised MARPOL Annex VI, Reg.4) and  IMO Res. MEPC.259(68)
Surveyor FABF Zhiyong
Responsible Office RINA China Marine



UNIT VERIFICATION CONFORMITY (MODULE G)
CERTIFICATE No.  MED296521WS

This is to certify
that RINA Services S.p.A. did undertake the relevant conformity assessment procedures for the equipment of the manufacturer identified below, which was found to be in compliance with the Marine-Pollution prevention requirements of Marine Equipment Directive (MED) 2014/90/EU, including the requirements and testing standards of (EU) 2021/1158.
MED Item Nº MED/2.10
Description On board exhaust gas cleaning systems
Type Open Loop Scrubber
Identification S/N.: 100SC1 & 100SC2,
Intended for: M/V FINNECO I (IMO 9856830, RI 97927)
Applicant Langh Tech Oy Ab
Alaskartano, Vanhamakarlantie 29
21500 Piikkio
FINLAND
Testing standards IMO Res. MEPC.259(68)
Reference standards IMO Res. MEPC.176(58) - (Revised MARPOL Annex VI, Reg.4) and  IMO Res. MEPC.259(68)
    
Issued in CHINA 
on November 15, 2021

This Certificate consists of this sheet plus an attachment
This certificate authorises the Manufacturer or his authorised representative established within the Community to affix the following symbol on the equipment above identified.
0474 /21
 

________________________________________
RINA Services S.p.A. - Hong Gu
RINA Services S.p.A.
**** NOTICE: This is NOT an official certificate ****
ATTACHMENT TO
CERTIFICATE No. MED296521WS

Verified components of the equipment (with serial number)
S/N.: 100SC1 & 100SC2,
Intended for: M/V FINNECO I (IMO 9856830, RI 97927)
Technical documentation
1. Following statutory document have been approved/filed in compliance with IMO Res. MEPC.176(58) - (Revised MARPOL Annex VI, Reg.4) and IMO Res. MEPC.259(68):
1.1 Onboard Monitoring Manual (OMM), PLMC/1527,
1.2 Technical Manual, Scheme B (ETM-B), PLMC/1526,
1.3 SOx Emission Compliance Plan, Scheme B (SECP), PLMC/1528,
1.4 EGC Record Book, PLMC/4098.

2. Product description:
The EGCS installed onboard the vessel consists of two (2) scrubber towers for cleaning the exhaust gas from two main engines respectively. Exhaust gas emissions of the main engines can be cleaned by the EGCS equivalent to using fuel oil with Sulphur content upper limit value of 0.1% m/m. This emission compliance is monitored continuously by measuring and recording of SO2(ppm)/CO2 (%) ratio and other key parameters as specified in the Technical Manual ETM-B with approval No. PLMC/1526.

3. Completed Tests on board were carried out and witnessed by RINA surveyor on 06/10/2021 in accordance with IMO Res. MEPC.259(68) & approved documents, and relevant testing reports/ records are listed as below:
1. Commissioning test report.
2. EGC history data recording report during sea trial tests.
3. Bunker Delivery Notes.
4. FAT report for automation system.
5. Calibration protocols/certificates of CEMS and water monitoring sensors.
6. Span gas certificates.
7. RINA testing certificate for main components.
8. Wash water sample analyses report issued by recognized laboratory.

Limitation on the acceptance or use of the product
The maximum exhaust mass flow rate is 94,320 kg/h for each EGC unit, and the maximum Sulphur content of fuel oil is 2.8%. For other operating limits, technical manual ETM (PLMC/1526) is to be referred.
____________________________
General condition of approval
a) This certificate will not be valid if the manufacturer or user makes any modification to the equipment, which has not been notified to, and agreed with RINA

___________________________________
RINA Services S.p.A. - Hong Gu
RINA Services S.p.A.
**** NOTICE: This is NOT an official certificate ****