MED182524CSENGD- -  -  N- ISOHULK38CWR -N- S- S- -19/04/2024- Marine Equipment- - SN- S- - N-  - 1,070,802B2bisMarine EquipmentNumero Pratica,Direttiva,Norma,Schema,Richiesta,Validità,EmailR- MED182524CS- N-Mar 19, 20291070802
 
Form
  Marine Equipment(TO)
MED550024WS/001
Certification N. MED182524CS - (ENG)
Certificate date 19/04/2024
Type Protezione antincendio
Product Surface materials and floor coverings with low flame-spread characteristics: (a) decorative veneers
Item Nº MED/3.18a
USCG Category N° 164.112

Model or Denomin.
Items
ISOHULK38CWR
Applicant TAPE SOLUTIONS
Place of requester Willem van Boelrestraat 83  %  3067 LN Rotterdam  % NETHERLANDS
Tel. N.,Fax, Email ---, ---, ---
Directive (EU) 2023/1667
Standards IMO Res. MSC.307(88)-(2010 FTP Code)
Reference Documents Chap. II-2 and X of SOLAS 74 Convention, as amended, RINA Rules for the certification of Marine Equipment
Request 15/04/2024
Expire date 19/03/2029
EC TYPE-EXAMINATION (MODULE B) ENG
Vuoto Querysave
Enrico Cabella S

EC TYPE EXAMINATION (MODULE B)
CERTIFICATE No. MED182524CS

This is to certify that RINA Services S.p.A. (Notified Body No. 0474) did undertake the relevant type approval procedures for the equipment identified below, which was found to be in compliance with the Fire Protection requirements of Marine Equipment Directive (MED) 2014/90/EU, including the requirements and testing standards of Regulation (EU) 2023/1667.
MED Item Nº MED/3.18a
USCG Category Nº 164.112
Description Surface materials and floor coverings with low flame-spread characteristics: (a) decorative veneers
Type ISOHULK38CWR
Applicant TAPE SOLUTIONS
Willem van Boelrestraat 83,3067 LN Rotterdam,NETHERLANDS
Testing standards IMO Res. MSC.307(88)-(2010 FTP Code)
Reference standards Chap. II-2 and X of SOLAS 74 Convention, as amended, RINA Rules for the certification of Marine Equipment
Issued in Genoa on
This Certificate is valid until
April 19, 2024
March 19, 2029
This Certificate consists of this sheet plus an attachment

________________________________________
Enrico Cabella
RINA Services S.p.A.
**** NOTICE: This is NOT an official certificate ****

ATTACHMENT TO
CERTIFICATE No.  MED182524CS
Page 1 of 2





Product description

Self-adhesive aluminum tape (named ISOHULK38CW), having thickness 0.070 mm and mass per area of 116 g/m2. Such tape is glued on the joint between two rock wool panels covered with a reinforced aluminum foil having thickness 50 mm and density of 70 kg/m3 ± 10%.

Fields of application

As finishing material for all exposed interior and concealed or inaccessible surfaces.
The aluminium tape may be laid upon any non-combustible support having a thickness equal to or greater than 50 mm and density equal to or greater than 70 kg/m3.
On the basis of the value of the total heat release (Qt) and on the basis of the value of the peak heat release (qp) the material is deemed not generating excessive quantities of smoke nor toxic products in fire according to Annex 2 IMO 2010 FTP Code.
Tests carried out

Tests as per RINA Test Laboratory report No. 2018CS012322 dated 21 March 2019 issued according to:
  • IMO 2010 FTP Code Part 5.




ATTACHMENT TO
CERTIFICATE No. MED182524CS
Pages 2 of 2
The mark of conformity may only be affixed to the above type approved equipment and a Manufacturer's Declaration of Conformity issued when the production control phase module (D, E or F) of Annex II of the Directive is fully complied with a written inspection agreement with a Notified Body
XXXX/YY
"WHEELMARK FORMAT"

XXXX
Notified Body number undertaking surveillance module
YY
Last two digits of year mark affixed
     
______________________________________________
General conditions for the approval
a) The initial conditions verified by RINA at the time of the approval are to be maintained
b) Any changes to the initial conditions are to be promptly communicated to RINA, which reserves the right to repeat the relevant assessment
c) This certificate will no be valid if the manufacturer makes any changes or modifications to the approved equipment, which have not been notified to, and agreed with RINA
d) RINA personnel are to be allowed to witness during the performances of activities, upon their request
e) The activities are to be carried out in compliance with the RINA Rules and/or other applicable Rules

f) Should the specified regulations or standards be amended during the validity of this certificate, the product is to be reapproved prior to it being placed on board vessels to which the amended regulations or standards apply. 


__________________________________________
Enrico Cabella
**** NOTICE: This is NOT an official certificate ****