Product description:
The M1 series is a modular PLC system for normal and extreme environmental conditions.
Type | Description |
| M1 modules |
| AI2xx/xx* | Analog input module |
| AIC212*/ AIC214* /AIC206* | Condition monitoring module |
| AIO2xx/xx* | Analog I/O module |
| AIO2xx/SI* | Analog I/O module |
| AO2xx/xx* | Analog output module |
| BS2xx/xx* | Backplane with different slot(s), BS2xx/E, BS2xx/S, BS2xx/ET |
| CF200/xxxx* | Compact flash card |
| CFA200/x* | CFast Card |
| CM202* | CAN-Bus module (Master) |
| CNT204/x* | Counter module |
| DA3284-C | Digital Analog Input/Output |
| DI2xx/xxx* | Digital input module |
| DIO2xx/x* | Digital input/output module |
| DIOxxx-C | Digital Analog Input/Output |
| DO2xx/xx* | Digital output module |
| DOR206/xxx* | Digital output relay module |
| DPM200 | Profibus module |
| EM2xx* | Ethernet master module |
| FM2xx* | Fastbus master module |
| FS2xx/x* | Fastbus slave module |
| GIO212* | General I/O module |
| GM260* | Grid measurement module |
| GMP232/x* | Grid measurement protection module |
| GMP232/x2* | Grid measurement module |
| GSP274* | Grid measurement, synchronization and protection module |
| ISI2xx/x* | Encoder interface module |
| LM201, S2xx* | Dummy module |
| MC205* | CPU module |
| MC206* | CPU module |
| MC210* | CPU module |
| MC212* | CPU module |
| MC220* | CPU module |
| MH230* | CPU module |
| MX2xx/x* | CPU module |
| NT2xx* | Power supply 24/48VDC |
| PTAI216* | Temperature recording module |
| TI214/x* | Temperature recording module |
| PVA202*/PVA208* | Proportional valve amplifier |
| RS204/x* | Interface module RS232, 422, 485, TTY |
| * all cc Modules included |
TYPE APPROVAL CERTIFICATE |
No. ELE280822XG |
Enclosure - Page 2 of 2 |
M1 series |
Type | Description |
| Safety modules |
| SAI205** | Safety analog Input module |
| SDI208 (cc)** | Safety digital input module |
| SDO204 (cc)** | Safety digital output module |
| SLC284 (cc)** | Safety logic controller |
| SCT202 (cc)** | Safety counter module |
| ** only cc Modules in certification |
Main characteristics:
Power supply: 24VDC nominal voltage
Ambient temperature: up to -40°C ...70°C (depending of the module type)
Degree of protection: IP20
Firmware version: M-Base V4.xx
Documents:
- Catalogue KA-System/EN, 11/2018
Test reports:
Bachmann: - 12718.00.03/04; 12718.00.05/06/11; 12718.00.10; 12718.00.13/14/17/18; 12718.00.19; 12718.00.20;
- 12718.00.21 Rev. 001; 12718.00.22; 12718.00.23; 13228-000-10; 13228-000-19,20; 13228-000-21; 13228-000-22;
- 13228-000-3,4; 13228-000-5,6,11; 13228-000-9; 13228-002-13,14,15,16,17,18; No13 - 18,EMC,Interference,Test,Report, Marine012,REV000; No19,20,EMC,Emission,Test,Report,Marine012,REV000; No3,4,Power,Supply,Failure, and,Variation,Test,Report,Marine012,REV000; No5,6,11,Dry,Heat,Damp,Heat,Cold,Test,Report,Marine012,REV000; No9,10,Insulation,Resistance,and,High,Voltage,Test,Report,Marine012,REV000; - 1R_M1_System_und_ Runtime_SW_REV000; 2R_Test_Configuration_Marine006_REV002;
TÜV SÜD Product Service GmbH: - 14312-52016-01 Ed. 1 dated 13 November 2014; 713051191 dated 2014-11-25;
- 713077298 Rev. 1 dated 2016-02-16; 713079418 dated 2016-04-06; 71392594A Rev. 1 dated 2011-10-14;
- 71392594b dated 2011-09-15; No14,EMC,Interference,TR-713278061-00,Marine012,REV000; No14,EMC,Interference,TR-14312-24452-01 Ed.2,Marine012,REV000; No7,Vibration,TR,713252021-00,Marine012,REV001;
Treo: - No22,Compass,Safe,Distance,433-22,V1U,Test,Report,Marine012,REV000;
Remarks:
- The equipment fulfils the EC-Code: 3a3.
- The EMC requirements for installation on the Bridge and Deck Zones will be fulfilled by the equipment, if the filter acc. to the M-Base V4.xx Operating manual will be used in power supply line.
- The GMP232/x2* module is not to be installed in the bridge and deck zone.
- Drawings of each system configuration is to be sent for approval before installation on board.
- In case of major software modification detailed information and suitable documents are to be submitted to the Society. |
|